3 Gang Toggle Switch Panel with Glass Fuse and ABS Housing for Marine Switch Panel 12V 24V

AS31 12V 24V 3 Gang Toggle Switch Panel with Three Glass Fuses, ABS Housing, 15A Total

The AS31 is a compact toggle switch panel for 12V and 24V circuits, built on an ABS face plate with three glass fuse tubes set into the housing. Three 5A fuses give 15A of protection in total, so a shorted pump, lamp or accessory blows its own fuse instead of taking the harness with it. Wiring is direct: feed in, load out, fuse in the protected leg.

AS31 At a Glance

• Layout: three-position toggle switch panel, one circuit per position.
• Fusing: three 5A glass fuse tubes built into the panel, 15A combined.
• Housing: ABS face plate, moulded, light and non-corroding in damp compartments.
• Voltage: suits 12V and 24V DC systems.
• Switching: lever toggle action that stays where it is set, readable without a legend card.
• Service: fuse tubes are replaceable from the panel face, no dismantling needed.

Why a Fused Toggle Panel

• Protection where the circuit starts. Because each 5A fuse sits at the panel rather than in a remote holder, the protected run begins at the switch and the cable downstream is covered.
• Fault finding in seconds. A blown glass tube is visible through the fuse body, so the faulty circuit is identified on the spot instead of by elimination.
• ABS in wet compartments. The moulded housing does not rust or swell, which suits engine bays, lockers and dashboards where metal plates corrode.
• Simple installation. Three circuits, screw terminations and a panel that mounts on a flat surface, so a fitter can commission it in a short stop.

AS31 Key Attributes

Typical Installations

• Boats and ribs: nav lights, deck lights, bilge pump and horn circuits.
• RVs and camper vans: interior lighting, water pump, vent fan and accessory sockets.
• Trucks, tractors and UTVs: work lamps, beacons and auxiliary circuits.
• Workshops and cabins: small fused distribution points on 12V or 24V supplies.

Installation Notes

• Confirm each load draws less than the 5A fuse fitted, and change the tube if a circuit needs more.
• Mount on a flat, dry surface with clearance behind the panel for terminal access.
• Terminate the supply side first, then the loads, and test each position before closing up.
• Keep a spare set of glass tubes on board, since they are the only consumable in the panel.

Ordering Information

Minimum order: 1 piece. Price: negotiable, quoted against quantity and fuse configuration. Packing: neutral box. Lead time: 5-7 working days. Payment: T/T, L/C. Shipments can run on EXW, FOB, CFR, CIF or DDP terms.

Buyer Questions